76
MOORE POSITIONER INSTALLATION AND SERVICE INSTRUCTIONS
INSTALLATION
Refer to Figure 1 for mounting dimensions and connections. A centering washer (customer provided) which
fits the I.D. of the range spring should be used. This acts as a spring seat and keeps the spring from shifting.
Mounting hardware is included with the positioner in a plastic bag numbered 10448-88. It contains (6)
mounting screws and washers, (1) range spring seat and (1) gasket.
CAUTION
Exceeding the specified ambient temperature limits can adversely affect
performance and may cause the positioner to fail.
1. Place centering washer on the actuator’s diaphragm or piston.
2. Place the positioner range spring on the center of the actuator diaphragm or piston.
3. Place the gasket on the mounting flange of the actuator top works. Substitute the P/N 10636-59
centering diaphragm for the gasket if the P/N 12388-6412 or 12395-6412 range spring is used.
4. Place the positioner range spring seat on the center nut of the positioner diaphragm assembly.
5. Hold the spring seat and guide the positioner and seat onto the range spring.
6. Orient the positioner for desired location of connections.
7. Insert mounting screws and washers and tighten screws.
PNEUMATIC CONNECTIONS
1. All connections are 1/4” NPT.
2. The piping recommended for the positioner is 1/4” O.D. tubing for the INSTRUMENT (input)
connection and 3/8” O.D. tubing for the supply connection. However, any scale-free piping may be used.
3. Blow out all piping before connections are made to prevent dirt, chips, etc., from entering the positioner.
4. Use pipe sealant sparingly and then only on the male threads. A non-hardening sealant is strongly
recommended.
5. Connect the positioner to a source of clean, dry, oil-free instrument air supply (see INSTRUMENT AIR
REQUIREMENTS).
CAUTION
Pressure in excess of 150 psig to any connection may cause damage.
Содержание VALVES SP160 Series
Страница 1: ...VALVES INSTALLATION OPERATION MAINTENANCE ...
Страница 78: ...78 MOORE POSITIONER INSTALLATION AND SERVICE INSTRUCTIONS ...
Страница 91: ...VALVES IOM REV 8 22 ...