Sperry Marine NAVIKNOT 600 SE, Руководство по эксплуатации, установке и обслуживанию

Страница: 55 / 138

NAVIKNOT 600 SE 056349/C
Electrical Installation 5-7
CDU Service Setup – Parameters
CDU ID
Sets the CDU’s local ID.
The ID serves to identify the individual CDUs in systems where one or
more remote CDUs are installed. The electronics unit uses the ID to keep
track of which CDU is currently assigned master command.
Setting: 0 – 9
Select an ID between “1” and “9” if more than one CDU is
installed. A given ID may only be assigned to one CDU
within the system.
In a single-CDU system, select ID “0”.
Dimming
Group ID
Assigns the CDU to a dim group.
The ID setting is only effective if dimming commands are read from the
proprietary NMEA sentence $PPLAI.
Setting: 00 – 99
Select an ID between “01” and “09” to assign the CDU to
the respective dim group.
Selecting ID “00” lets the CDU accept any dim command
received, regardless of group assignment.
Central Dim Offset
Sets a local offset for the brightness level.
Setting: -7 – +7
Select an offset as required to match the brightness of the
CDU to that of other equipment controlled through the same
dim command device.
Offsets below 0 decrease, offsets above 0 increase the
CDU’s overall brightness by the corresponding number of
brightness levels. However, the offset will not alter the
brightness beyond the min. and max levels respectively.
The factory default for the offset is 0.
Dim Values (min. through max.)
Maps the ordered brightness setting as read from the serial dim com-
mand to the NAVIKNOT 600 SE’s nine discrete brightness levels.
Settings: 00 – 99
For each brightness level, set the smallest intensity order at
which the level should be active. If the order received is
smaller than the set value, brightness is reduced to the next
lower level.