Sperian MILLER Vi-Go, Руководство пользователя

Страница: 12 / 18

U s e r I n s t r u c t i o n s - E n g l i s h
12
5.5 Installation of Cable
and Tensioning Assembly
to Bottom Bracket Assembly
1. Install saddle clips loosely around cable attached
to tension rod (see Fig. 6).
2. Slide the tension rod down the cable and through
the hole in the bottom bracket until a sufficient
amount of threads are through to install the com-
pression spring, washer and tensioning nut.
3. Remove excess cable by pulling cable through the
saddle clips. Tighten and torque saddle clips to 40
to 45 ft. lbs.
4. Tighten tensioning nut until cable is taut. Com-
press spring until the distance of 5-1/2” is
achieved. Do not completely compress spring. If
an insufficient amount of threads are exposed,
repeat procedure from Step 3.
5. When proper tensioning of cable is achieved,
install jam nut against tensioning nut.
6. Discard excess cable by cutting below the lower
saddle clip, leaving approximately 3” of cable
below the lower saddle clip (3” is recommended; a
minimum of 1” is required).
Fig. 6
Saddle
Clip
Compression
Spring
Tension
Rod
Washer
Jam Nut
Tensioning
Nut
IMPORTANT: After installation is complete, a final inspection of the system, ladder and structure is
required. Using a hand punch, designate the appropriate system capacity rating, installation date and service/in-
spection dates using the spaces provided on the label. Attach the label to the ladder or structure with the nylon tie
provided. Attach the label to the system where it is easily accessible to anyone using the system. Record system
identification information in the inspection and maintenance section of this manual.
▲ Complete Bottom Bracket
Assembly with
Tensioning Assembly and
Cable Installed
5-1/2"