Spencer EVA, Руководство пользователя

Страница: 13 / 22

13
3. Press with your fingers the two red levers upwards (fig. 18).
4. Pull up to full opening the lift bar and release the buttons.
5. Verify that the lift bar is locked in the extended position.
The use of the lift bar is only intended for the phases of descent with the slides open.
Before moving the device, check the proper locking of the lift bar, the failure to respect this warning may cause damage to
the device, the operator and patient.
For closing the lift bar:
1. Take position in the rear part of the device.
2. Grasp the lift bar with both hands near specific rubber parts (fig. 19).
3. Press with your fingers the two red levers upwards.
4. Pull down to full closing the lift bar and release the buttons.
5. Verify that the lift bar is locked in the closed position.
Before moving the device, check the proper locking of the lift bar, the failure to respect this warning may cause damage to
the device, the operator and patient.
4.3.9
Functioning of footrest (if equipped)
For opening the footrest:
1. Carry out the operations for the opening of the chair.
2. Take the footrest and recline it until complete opening towards the front of the chair (fig. 20).
3. Make sure that the footrest is properly reclined.
Before transferring the patient on the chair and using the footrest, make sure it is properly secured to the structure of the
chair.
The footrest is not designed to support the total weight of the patient, but only to give greater comfort when he is sitting
on the chair, the failure to do so may cause damage to the device, the operator and patient.
For closing the footrest:
1.
With the chair open, take the footrest and
recline it towards the rear part of the chair,
up to its complete closure (fig. 21).
2.
In the case it is desired to close the chair,
perform all the operations explained above
in this manual, in this case the footrest has
a mechanism that allows to automatically
close again.
3.
Before using or storing the chair, make
sure that the footrest is properly closed.
Fig. 18
Fig. 19
Fig. 20 Fig. 21