![background image](http://html.mh-extra.com/html/spel/vortceptor/vortceptor_installation-manual_1346433004.webp)
4 Installation Manual
Vortceptor
Diversion
Chamber
Installation
Always physically check measurements on the diversion chamber prior to
installation.
YES / NO
Prepare the diversion chamber excavation, this is to be benched or battered
to suit the site constraints.
YES / NO
Ensure sufficient room is left to install inlet pipe (Remember you will need to
angle the pipe to feed it in).
YES / NO
Lift the Diversion Chamber into the excavation - ensure site specific safety
requirements are adhered to.
YES / NO
Adjust the Diversion Chamber to a correct level so the rectangular opening
matches the Vortceptor. The inlet and outlet block outs are to match the
drainage line.
YES / NO
Use the template provided with the Vortceptor to drill the bolt holes into the
diversion chamber rectangular void.
YES / NO
Use Sikaflex or silicone (by others) to seal the Vortceptor to the Diversion
Chamber, use 8.5mm 4 cutter SDS bit to drill the bolt holes.
YES / NO
Use M8 x 100mm Galvanised screw bolts to fix the Vortceptor to the Diversion
Chamber.
YES / NO
Associated
Drainage
& Finishing
Works
Install upstream and downstream drainage pipework.
YES / NO
Connect the pipework (by others) to the Diversion Chamber, concrete
bandage the inlet and outlet pipes to the Diversion Chamber.
YES / NO
Internally render the inlet and outlet pipework with C-Crete or similar render.
YES / NO
Use low slump concrete to mass infill and bench the base of the diversion
chamber and weir. This is to direct the flow and remove any dead zones in the
diversion chamber.
YES / NO
Cover Slab
Installation
Use a Sikaflex bead around the rebate on the top of the Diversion Chamber
to ensure a satisfactory seal between cover slab (Lid) and chamber.
YES / NO
Lift and install cover slab, ensure manhole void / cover is on Vortceptor side of
the chamber.
YES / NO
Use Sikaflex and screw bolts to secure fibreglass manhole riser to cover slab.
YES / NO
Tie in the manhole covers as per lid manufacturers installation guidelines, to
achieve Finished Surface level.
YES / NO
Содержание Vortceptor
Страница 1: ...SPEL Vortceptor spel com au Installation Manual ...
Страница 9: ...spel com au 9 ...
Страница 10: ...10 Installation Manual Vortceptor ...
Страница 13: ...spel com au 13 ...