EN
Receiver Installation and Setup
Install the Receiver in your vehicle using double-sided foam servo tape. Foam
servo tape will hold the receiver in place and help isolate it from vibrations.
Mount the antenna up and away from the vehicle. The higher up the antenna
is, the better signal it will receive.
NOTICE:
Do not cut or modify the antenna.
Powering the receiver with an ESC
Receiver
Battery
To Motor
Electronic
Speed Control
Steering Servo
Steering Servo
Throttle Servo
Battery
Receiver
Powering the receiver with a separate receiver pack
Failsafe
Failsafe position is set during binding. In the unlikely event that the radio link
is lost during use, the receiver will drive all channels to its pre-programmed
failsafe position (normally neutral or full brakes). If the receiver is powered on
prior to turning on the transmitter, the receiver will enter the failsafe mode,
driving the throttle channel to its preset failsafe position. When the transmitter
is turned on, normal control is resumed.
IMPORTANT:
Failsafe activates only in the event that signal is lost from the
transmitter. Failsafe will NOT activate in the event that receiver battery power
decreases below the recommended minimums or power to the receiver is lost.
