TLW1977N_SVG
1
1.
Wood Block
Figure 9
4.
Place rubber cups (from accessories bag) on all four leveling
legs.
TLW1979N_SVG
5
4
3
2
1
1.
Level
2.
Locknut
3.
Leveling Leg
4.
Rubber Cup
5.
Washer Base
Figure 10
5.
Place a level on the cabinet top and check if the washer is lev-
el from side to side and front to back.
6.
If washer is not level, tilt washer back to access the front lev-
eling legs. Loosen the locknuts and adjust legs by screwing
into or out of washer base.
7.
Once adjusted, tilt the washer forward on front legs and lower
back down into position to set the rear self-leveling legs.
8.
Washer must not rock. When washer is level and does not
rock, tighten locknuts securely against bottom of washer base.
If these locknuts are not tight, washer will not remain station-
ary during operation.
Improper installation or flexing of weak floor will cause exces-
sive vibration.
Do not slide washer across floor once the leveling legs have been
extended, as legs and base could become damaged.
9.
Verify that unit does not rock.
Plug In the Washer
Electrical Requirements
120 Volt, 60 Hertz with 3-Prong Earth/Ground Plug
NOTE: The wiring diagram is located in the control
hood.
WARNING
To reduce the risk of fire, electric shock, serious in-
jury or death, all wiring and protective earth/ground
connections MUST conform with the latest edition of
the National Electrical Code, ANSI/NFPA No. 70, and
such local regulations as might apply. It is the cus-
tomer’s responsibility to have the wiring, fuses and
circuit breakers installed by a qualified electrician to
make sure adequate electrical power is available to
the washer.
W824
When plugging in the washer:
• DO NOT overload circuits.
• DO NOT use an extension cord.
• DO NOT use an adapter.
• DO NOT operate other appliances on the same circuit. Use
separately fused 15 Amp circuits.
The washer is designed to be operated on a separate branch, po-
larized, three-wire, effective earth/ground, 120 Volt, 60 Hertz,
AC (alternating current), circuit protected by a 15 ampere fuse,
equivalent fusetron or circuit breaker.
The three-prong earth/ground plug on the power cord should be
plugged directly into a polarized three-slot effective earth/ground
receptacle rated 110/120 Volts AC (alternating current) 15 Amps.
Refer to
Figure 11
to determine correct polarity of the wall re-
ceptacle.
Installation
Part No. 202955R1
©
Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
9
Содержание AWNE92SP
Страница 2: ......
