4.
Tighten strap to hold hose to standpipe. This will prevent the
drain hose from dislodging from drain receptacle during use.
TLW2220N_SVG
5
6
4
3
2
1
1.
Ribbed Portion of Drain Hose
2.
Standpipe Adapter
3.
Beaded Strap
4.
Standpipe - 2 in. [51mm] or 1-1/2 in. [40 mm] Diameter
5.
36 in. [914 mm] Recommended Height
6.
12 in. [305 mm]
Figure 5
Low Standpipe Installation
If standpipe is lower than 36 inches [914 mm], you must install
No. 562P3 Siphon Break Kit. Refer to
Figure 6
. This kit is avail-
able (as optional equipment at extra cost) through an authorized
dealer or parts distributor. Installation instructions are supplied
with the kit.
TLW2221N_SVG
2
1
3
1.
562P3 Siphon Break Kit
2.
Standpipe
3.
Drain Hose
Figure 6
Wall Installation
For installations of this type, the drain hose MUST be secured to
one of the fill hoses using the beaded strap from accessories bag.
Refer to
Figure 7
.
NOTE: End of drain hose must not be below height of
cabinet top.
W329I_SVG
2
1
1.
Beaded Strap (tape if necessary)
2.
Standpipe Adapter
Figure 7
Laundry Tub Installation
For this type of installation, the drain hose MUST be secured to
the stationary tub to prevent hose from disloding during use. Re-
fer to
Figure 8
. Use the beaded strap (supplied in accessories
bag) to secure hose.
We recommend leaving the standpipe adapter on the drain hose
for this type of installation.
TLW2222N_SVG
1
1.
Beaded Strap (tape if necessary)
Figure 8
Position and Level the Washer
1.
Position washer so it has sufficient clearance for installation
and servicing.
2.
Place washer in position on a clean, dry, and reasonably firm
floor. Installing the washer on any type of carpeting is not
recommended.
3.
For easier access to leveling legs, prop up washer with a
wooden block.
Installation
8
©
Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
Part No. 202955R1
Содержание AWNE92SP
Страница 2: ......
