ALWAYS
block the wheels to prevent movement of the log splitter while in operation.
KNOW
how to stop the log splitter and disengage the controls before operating it.
NEVER
place hands or feet between the log and splitting wedge during forward or reverse stroke as this could result in
serious injury or death.
NEVER
straddle or step over the log splitter during operation.
NEVER
reach or bend over the log splitter to pick up a log.
NEVER
try to split two logs on top of each other.
NEVER
try to cross split a log.
NEVER
attempt to load the log splitter when the ram or wedge is in motion.
NEVER
use your foot, a rope or any extension device to operate the control lever on the valve. Only use hand.
NEVER
move the log splitter while the engine is running. Shut off the engine if you are leaving the log splitter, even for a
short period of time.
NEVER
touch the muffler and other hot areas of the engine during operation. Wait until the engine cools down.
GENERAL REPAIR
NEVER
operate your log splitter when it is in poor mechanical condition or in need of repair.
NEVER
alter your log splitter in any manner. Such alterations may cause your log splitter to be unsafe and will void the
warranty.
NEVER
tamper with the engine to run it at excessive speeds. The maximum engine speed is preset by the manufacturer
and is within safety limits. Refer to the engine owner’s manual for your particular log splitter.
NEVER
perform any service or repair on your log splitter without first removing the spark plug wire.
ALWAYS
perform all recommended maintenance procedures before using your log splitter.
ALWAYS
check the level of hydraulic oil and engine oil before operation.
ALWAYS
periodically check that all nuts, bolts, screws, hydraulic fittings and hose clamps are tight.
ALWAYS
replace all damaged or worn parts immediately.
ALWAYS
be sure that all replacement parts meet manufacturer’s specifications.
Page 4
