SPEDIX S250, Руководство пользователя

Страница: 13 / 47

D
RONE
T
EAM
P
ROJECT NO
. 2015-1-ES01-KA202-015925
4.M
ODULE OF
A
DVANCED
F
RAME
10
•
Why does this procedure do?
The motors used for Spedix are called brushless motors. These motors work in conjunction with
an ESC (Electronic Speed Controller) and APM to control them.
The APM processes the value that sends the station and he sends it to the ESC to vary the speed
of the motors. As the value sent to the ESC is directly the value of the station, the motors must
be prepared to don´t start rolling just start moving the stick of the transmitter, so you change
the minimum value that begin move motors with this procedure.
Once we make these steps, the procedure is as follows (for connecting both ways):
•
Connect a tricolored cable channel 8 RC receiver to the port channel 8 OUTPUTS APM
2.6. This will cause the receiver to work when the battery is connected.
• With the transmitter battery still connected and disconnected, the throttle stick will
move to its maximum position.
IMPORTANT: Be sure the propellers are not placed before the next step.
• Connect the battery, starting a small tune, followed by a short beep sounds.
• Move the throttle stick to a position about 25% of full throttle and leave it alone, two
short beeps and long will be heard, this indicates that the procedure was successful.
• Place the throttle stick to the minimum and carefully check the throttle stick moving the
motors begin to move about 25% of the value of the maximum throttle.