Spectrum Winco EGD-24M, Инструкция по установке и эксплуатации

Страница: 9 / 12

9
NOTE:
1) FOR SUPPLY CONNECTIONS USE COPPER WIRE ONLY,
SUITABLE FOR AT LEAST 194°F (90°C). USE WIRE GAUGE
SHOWN OR LARGER
2) ALL INTERNAL WIRING IS #14 GA
SINGLE PHASE CONNECTION
3 PHASE CONNECTION
THERMOSTAT 2 THERMOSTAT 1
PILOT LIGHT 1 PILOT LIGHT 2
ON/OFF SWITCH 1
ON/OFF SWITCH 1
3 PHASE CONNECTION
SINGLE PHASE CONNECTION
ON/OFF SWITCH 2
ON/OFF SWITCH 3
ON/OFF SWITCH 2
HEATING ELEMENTS 1 HEATING ELEMENTS 2
THERMOSTAT 2 THERMOSTAT 3 THERMOSTAT 1
PILOT LIGHT 2 PILOT LIGHT 3 PILOT LIGHT 1
HEATING ELEMENTS 1 HEATING ELEMENTS 2 HEATING ELEMENTS 3
NOTE:
1) FOR SUPPLY CONNECTIONS USE COPPER WIRE ONLY,
SUITABLE FOR AT LEAST 194°F (90°C). USE WIRE GAUGE
SHOWN OR LARGER
2) ALL INTERNAL WIRING IS #14 GA
Electrical Diagram
The circuit diagrams are provided to assist qualified technicians. Only SPECTRUM agents or Recommended Qualified Technicians
should carry out repairs if needed. (Refer to page 11 for service arrangements)
DO NOT remove any components or service panels on this product.
EGD-24M
EGD-36M