Spectrum Winco EGD-24M, Инструкция по установке и эксплуатации

Страница: 5 / 12

5
Operation
6. Remove the excess fat and wipe clean. Griddle surface is ready
for use.
NOTE
EVEN WITH CAREFUL SEASONING, FOOD CAN STICK TO
THE GRIDDLE COOKING SURFACE UNTIL GRIDDLE PLATE IS
“BROKEN IN”.
Before operating the griddle, it must be checked to see that it
is sitting level. Adjust the feet to level the griddle. Be sure the
catch tray has been assembled correctly (see image below).
Catch Tray
Rack
NOTE
Upon first use, griddle can produce a burning metal smell.
This is normal and smell will decrease with use.
Season the surface
1. Clean griddle surface thoroughly. After griddle has been cleaned, it
must be seasoned to prevent food from sticking. Follow the steps
below for the correct heating method to season the griddle before
use and after scouring.
2. Switch to ON and adjust the thermostat dial knob to 350°F.
3. Use a clean cloth (not a spatula), to spread a thick film of cooking
oil or fat over the griddle cooking surface. Film must remain on hot
griddle for 30 minutes.
CAUTION
GRIDDLE SURFACE WILL BE HOT
PLAQUE SURFACE SERA CHAUD
4. Remove the excess fat and wipe clean.
5. Apply another film of cooking oil over hot cooking surface for
another 30 minutes.
Temperature Control
Your griddle should be turned on prior to usage to allow the cooking
surface to warm up; 5-7 minutes is sufficient.
To get efficient use from this unit, it is recommended that for
intermittent use that the thermostat be turned down when not
cooking. This will assist in reducing power consumption and also allow
for quicker heat response when needed.
It is recommended that the cooking surface is lightly greased before
each use.
The temperature is thermostatically controlled.
The set point of each thermostat is marked on the front panel with
"TEMP  " in the 9 o’clock position. Griddle is equipped with one
thermostat per various cooking surface segments.
Cooking
Switch griddle to ON and adjust the thermostat dial knob to the
desired temperature. After a short pre-heating period, the thermostat
will automatically maintain the selected temperature. When the set
temperature is reached, the signal light will go OFF.
A temperature setting of between 375ºF and 430ºF will be sufficient
for general cooking. This may vary for particular food types, individual
needs, or experience.
Simply place the food products on the grilling surface and cook to
manufacturer's specifications.
TO AVOID SERIOUS PERSONAL INJURY:
• ALWAYS install equipment in an area with adequate light and space.
• ONLY operate on a solid, level, nonskid surface that is
nonflammable and away from sinks and water hazards.
• NEVER bypass, alter or modify this equipment in any way from
its original condition. Doing so can create hazards and will
void warranty.
• NEVER operate the griddle without all warnings attached to it.
burn hazard.
When in operation, the
Conveyor Toaster will be hot at
the entrance to the conveyor
cavity.
please take extreme caution.
Risque de brûlure.
Ne touchez pas les surfaces chaudes ou
chauffées liguid tout appareil chauffe ou
en fonctionnement.
use cAutIoN WheN
touchING the uNIt.
Ne touchez pas le liquide chaud
ou les surfaces de chauffage
lorsque l’appareil chauffe ou en
fonctionnement.
WARNING
AVERTISSEMENT
HOT