Spectrum WatchDog Wireless Rain+Temp Station, Руководство по эксплуатации продукта

Страница: 12 / 20

12
While holding the bracket close
enough to the container to avoid wire
tension, move the power switch into
the “ ON ” position. The correct “ ON ”
position (see image to the right) will
reveal the circular hole in the switch
body (also see the ‘ ON ’ label on the
circuit board). After switching the
device on, you should see three flash-
es from the green LED (positioned on
the circuit board, near the base).
You can now use SpecConnect or the Watchdog Mobile App to
complete the configuration of the device and monitor incoming
data (see pp. 6 - 9). Note: It can take up to three minutes for data
sent from the Station to appear on SpecConnect.
Optional: Once configuration is complete, you can test the func-
tion of the Station by manually toggling the tipping spoon sever-
al times and watching for the data to appear in SpecConnect or
the WatchDog Mobile App. Remember, each tip represents
0.01inches (0.25mm) of rain. If no data is transmitted, see the
calibration section of this manual to check for proper tipping
spoon adjustment.
Carefully place the electronics assembly back into the electron-
ics cylinder and replace the blue cap.
6. Install the Bird Guard
Install the bird guard kit onto the Rain Bucket before returning
the bucket to the base. Refer to the instructions included in the
bird guard kit.
7. Replace the Rain Bucket
Rotate the bucket such that the tabs engage the screws. Tighten
the screws with a Philips head screw driver.