Leg adjustment
0191978R4 Page 2 of 4
1. Orient the modesty panel/cord channel as shown and attach to the
legs with (4) 1/4-20 x 5/8” PHM screws.
Figure 2.1
.
2. Install the (4) glides to the bottom of the legs. The glides can be
adjusted later to keep the desk level on uneven surfaces.
3. Tighten ALL screws.
Figure 2.1
Modesty panel /
cord channel
1/4-20 x 5/8” PHMS
(4 required)
Glides
(4 required)
The worksurface height can be adjusted from 24”H - 32”H in 1” increments.
Figure 2.2
. Adjustment is easier when the desk is upside-down.
1. To adjust the legs, remove the (4) pre-installed adjustment screws.
(Fully-support the lower section of the leg while removing).
Figure 2.3
.
2. Choose a height and align the corresponding set of leg holes.
3. Install the (4) previously removed screws in the new holes and tighten securely.
4. Repeat this procedure on the second leg. Make sure to use the same set of
holes as used on the first leg.
Figure 2.2
Figure 2.3
Lower section
Up to 8” of
adjustment
Up to 8” of
adjustment
Adjustment
screws
8”
24”
32”
Install cord channel / modesty panel and glides
2
