0109742R3 Page 3 of 3
925 FIRST AVENUE, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM
© 2016 Spectrum Industries Inc., All rights reserved.
Door stop
7mm x 30mm
JC wood screw
Door stop
7mm x 30mm
JC wood screw
Worksurface
Worksurface
Base panel
Door stop
7mm x 30mm
JC wood screw
Base panel
Lock slot
Door stop
1/4” Washer
1/4-20
Locknut
Left
side panel
Left
side panel
1/4” Washer
Lock slot
3. Install door stops
1. On
36”H Inspiration lecterns
, open the door and install the upper
door stop to the worksurface, and the lower door stop to the base
panel-each with a 7mm x 30mm JC wood screw.
Figure 3A
.
Note: On the upper door stop, use the 1/4”
washer between the worksurface and door stop.
1. On
42”H Inspiration lecterns
, open the door and install the upper door
stop through the notch in the left side panel with a 1/4” washer and 1/4-20
locknut.
Figure 3B
.
2. Install the lower door stop to the base panel with a 7mm x 30mm JC wood
screw.
Figure 3B
Figure 3A
4. Door stop adjustment
1. The door stop can be rotated slightly to adjust the closed position of
the doors. To rotate, loosen the JC screw (or upper door stop locknut
on 42”H lecterns) slightly with a 4mm hex wrench.
Figure 4
.
2. Rotate the door stop until the door contacts the upper and lower
bumpers at the same time when closed. Also be sure the lock pawl on
the door will align and engage with the lock slot in the left side panel.
3. Re-tighten the JC bolt (or locknut) securely.
4mm Hex
wrench
(included)
Glide wrench (included)
or 7/16” wrench
(for 42”H lectern)
4mm Hex
wrench
(included)
Door stop
JC screw
Figure 4
Tools
Required
Tools
Required
