0116143R4 Page 4 of 7
4mm Hex
wrench
Tools
Required
Floor Anchoring (Toe Kick models only)
Figure 4
1/4-20 x 40mm JC bolt
(access from inside lectern)
4 req’d
Note: 4 fasteners are required
to anchor the toe kick to floor.
(fasteners not included).
LINK Lectern
Access panel
Toe kick
1/2” mounting
holes for floor
anchors
1.
If your LINK is equipped with a toe kick, and you wish to attach it to the floor, the toe kick
will need to be detached from the lectern. To detach, remove the (4) 1/4-20 x 40mm JC
bolts (one on each corner from inside the lectern) with a 4mm hex wrench.
2. Carefully lift the lectern off the toe kick. This will require several people.
Figure 4
.
3.
Locate the toe-kick into its final position on the floor and mark the (4) mounting hole
locations on the floor (The toe kick mounting holes are 1/2” dia.)
4.
Drill holes into your floor and anchor the toe kick with appropriate fasteners.
5. Carefully lift the lectern back onto the anchored toe kick and align the (4) mounting holes.
6. Re-attach the lectern to the toe kick with the (4) previously removed JC bolts.
7. The access panel can be removed to access wiring below lectern.
Wheel operation
Figure 8
Brake lever
1. To lock the wheel rotation, press the brake lever.
Figure 8
.
2. To resume operation, lift up on brake lever.
Moving and parking the lectern
• Before moving, unplug and secure all power cords.
• Close and lock doors.
• Remove any items from the top of the worksurface.
• Unlock the wheels.
• Push slowly and carefully. Do not move over uneven or irregular surfaces.
• Do not allow children to move.
• Lock the wheels after moving.
•
Do not park unit in areas of heavy traffic.
• Do not run power cords across hallways, classrooms, or other areas where they will be walked on.
• Do not leave unit unattended in areas where children have access.
• Keep doors closed and locked whenever unit is unattended or parked.
• Keep wheels locked whenever the lectern is unattended.
