Tools Required
1. Identify all location(s) and sizes for controller(s) or electronics while making sure
all devices fit within the maximum cutout space available in the overbridge panel.
See
Figure 3B-C
.
2. Locate and mark the exact cutout area(s) on the panel.
Note: Using masking
tape on cut lines will minimize laminate chipping while cutting.
3. Carefully make the cutout(s) in the overbridge panel using a jigsaw or router.
4mm Hex
wrench
Jigsaw or Router
Drill
Pencil
Masking
tape
Drill bit
Measuring
device
1. To remove the overbridge insert panel, remove the (2) 1/4-20 x 35mm JC bolts with a
4mm hex wrench and lift out the panel.
Figure 3A
.
2. To make cutouts in the insert panel [optional]:
3. Install controller(s) / electronics into panel.
4. Re-install the overbridge panel and secure with (2) 1/4-20 x 35mm JC bolts.
Overbridge insert panel (overbridge models only)
Note: The insert panel shown
(shaded)
is not included with the lectern or over-
bridge. This option needs to be ordered separately to complete the overbridge.
Figure 3A
1/4-20 x 35mm
JC bolt
Overbridge
panel
1/4-20 x 35mm
JC bolt
0103148R8 Page 4 of 11
