Handle
Right-Hand Hex Drive
Bar Assembly
Leg Drive
Shaft
1/4-20 x 5/8" PHMS
Right Leg
Crank Mount
Left Leg
Worksurface
A. Carefully flip the worksurface face-down onto a non-abrasive surface and orient the right leg as shown in
Figure 2
.
B. Attach the right leg and right-hand hex drive bar assembly to the worksurface using 1/4-20 x 5/8" PHM screws.
(Be sure the drive bar shaft is fully-inserted into the gear box before attaching.)
C. Attach the crank mount to the leg drive shaft, and attach to the worksurface with 1/4-20 x 5/8" PHM screws.
D. Connect the left and right-hand drive assemblies while engaging the drive mechanism. If necessary, the drive
mechanism alignment can be adjusted by turning the crank handle slightly.
E. Attach the left leg and drive assembly to the worksurface using (8) 1/4-20 x 5/8" PHM screws.
Left-Hand Hex Drive
Bar Assembly
2. Attach Legs & Drive Assemblies to Worksurface
055311R5 Page 3 of 7
A. Attach the T-supports to the worksurface using
(4) 1/4-20 x 1-3/4" PHM screws.
Figure 3
.
B. Attach the cord channel to the T-supports using
(4) 1/4-20 x 5/8" PHM screws.
C. Attach the chair rail using (2) 1/4-20 x 2" FHM screws.
D. Carefully flip the desk upright-this may take
several people.
Figure 3
Worksurface
T-Supports
Cord Channel
Chair Rail
1/4-20 x 5/8" PHMS
(4 req'd)
1/4-20 x 1-3/4" PHMS
(4 req'd)
1/4-20 x 2" FHMS
Figure 2
3. Attach T-Supports, Cord Channel & Chair Rail
055311R5 Page 3 of 7
