0117015R1 Page 6 of 21
set and go leg
1/4-20 x 5/8” PHMS
(4 required)
Figure 3B
3. Adjust leg height (set and go legs only)
To adjust leg height:
1. Remove both side panels to provide access.
Figure 3B
.
2.
Locate and remove the (4) 1/4-20 x 5/8” PHM screws that secure
the set and go leg. While these screws are removed, have a helper
support the detached leg.
3. Locate the height indicator window and slide the leg to the desired
height setting.
4.
Replace the (4) 1/4-20 x 5/8” PHM screws and tighten securely.
5. Repeat on the second leg using the same height setting.
Tables with adjustable-height set and go legs can be ad-
justed to have a worksurface height between 29”- 42” (in
1” or 2” increments).
Figure 3A
. The factory-set height
is 29”H. Adjustment to the leg height should be done
while the table is still upside down on the pallet.
Figure 3A
Phillips
screwdriver
Tools Required
Cordless drill
with long magnetic
Phillips driver
or
(best)
height indicator
window
Note: If you have a table with fixed or eLift legs, proceed to step 4.
