0117015R1 Page 5 of 21
glide
2. Install glides, end caps, and grommets
1. With the table still upside-down, install the glides onto the legs (4)
on fixed / set- and-go, (6) on eLift legs.
Figure 2
.
2. Install the end caps into the tube ends.
3. Install the (2) snap-in grommets from inside into the bottom panel.
(One of the side panels may need to be removed to gain access.)
Note: If you will be using an optional display
stand, do not install all 4 end caps. Install 2
on the side opposite the display stand only.
Figure 2
2 end caps
2 end caps
(do not install these 2
if using display stand)
glide wrench
(included)
Tools
Required
snap-in
grommet
snap-in
grommet
bottom
panel
