0112776R4 Page 6 of 9
5. Install grommets
A. Install (2) 4” snap-in grommets into the bottom panel.
Figure 5
.
B. Install (1) 3-1/4” grommet into the rear leg panel.
6. Install side panels
A. Attach the short side panel to the cord channel rails toward the rear
leg with (4) 1/4-20 x 30mm JC bolts.
Figure 6
.
B. Attach the long side panel to the cord channel rails toward the front
leg with (4) 1/4-20 x 30mm JC bolts.
C. Repeat procedure on the other side of the table.
Figure 5
Figure 6
3-1/4” round
grommet
4” snap-in
grommet
4” snap-in
grommet
rear leg
(with grommet hole)
side panel
(long)
side panel
(short)
rear leg
(with grommet hole)
bottom
panel
1/4-20 x 30mm
JC bolts
cord
channel rail
4. Flip table upright
A. Using 4-5 people, carefully tip the table up on
its side and over until upright.
Figure 4
.
CAUTION
The table is heavy when assembled.
Use caution when flipping upright.
Figure 4
Note: If an equipment rack has been
installed and will be permanent, the
short side panels will not be needed.
