0111252 Page 4 of 4
925 First Avenue, PO Box 400, Chippewa Falls, WI 54729 Ph: 1-800-235-1262 Fax: 1-800-335-0473
E-mail: [email protected] web: www.spectrumfurniture.com
A.
If your Inspiration lectern is the mobile version, lock all four casters.
B.
Set the edge of the assembled table onto the previously installed unit-to-unit bracket.
Figure 3A
.
C.
Align the bracket and worksurface mounting holes and attach with (3) 1/4-20 x 5/8” PHM screws (fi nger-tight only).
D.
Align the modesty panel and lectern side panel mounting holes and attach with (3) 8-32 x 3/8” PHM screws.
E.
Make sure the table is level side-to-side, and front-to-back, then tighten all screws securely-including the unit-to-unit bracket screws.
3. Attach Table to Lectern
3. Attach Table to Lectern
Figure 3A
Figure 3B
Modesty
Panel
Worksurface
1/4-20 x 5/8”
PHM screws
(3 req’d)
#8-32 x 3/8”
PHM screws
(3 req’d)
Lectern Side
Panel
Unit-to-unit Bracket
w/ slots
Note: The side table with casters is only designed for
short distance mobility and repositioning within a room.
Frequently moving the unit long distances or over uneven
thresholds is not recommended. Do not lift up or pull the
table-move the table and lectern together.
Assembled
Table
Note: The table worksurface should
be parallel with the lectern worksur-
face. The Unit-to-unit bracket has
slots that allow slight vertical adjust-
ment with the fasteners that attach it
to the side of the lectern. If adjust-
ment is necessary, loosen the fasten-
ers attaching the table to the lectern,
reposition the unit-to-unit bracket and
table, then retighten.
