Note: The core table should be fully-assembled in it’s final location
before proceeding with this installation. These end worksurfaces
should be installed before the side worksurfaces or center console
panel. If you have existing side worksurfaces and a center console
panel installed, they will need to be removed.
0115715 Page 1 of 3
Assembly Instructions
Important
Before you begin, please make sure all parts and proper quantities
are included. Any parts damaged during shipment must be reported
within 15 days of receipt. To report information regarding damage, to
purchase parts or accessories, or if you have any questions, please
contact us at:
www.spectrumfurniture.com
715-723-6750, 800-235-1262
Thank you for purchasing Spectrum products!
End worksurface for InVision Access Table
37118 - Curved
37119 - Rectangular
(24) 026064
1/4-20 x 5/8” PHMS
(4) 0115718
cantilever worksurface
bracket
(2) 036281
dual unit-to-unit bracket
37118
curved worksurface
37119
rectangular worksurface
cantilever
worksurface
bracket
(4 required)
1. Install cantilever worksurface brackets
1.
Make sure the table is upright. It may take 3-4 people to flip.
2. Tip the 4 cantilever end worksurface brackets while inserting
into the leg slots.
Figure 1A
.
The end worksurface brackets
have to be installed into the
slots before any worksurfaces
are installed. The end worksurfaces
will be installed first, then the side
worksurfaces (step 3), then center
console panel.
Figure 1A
Phillips
screwdriver
Tools
Required
(1) worksurface
0115713 - curved worksurface
0115722 - rectangular worksurface
