0115715 Page 2 of 3
Figure 1B
3. Set the end worksurface onto the brackets and align the mounting holes.
Figure 1B
.
4. Install two 1/4-20 x 5/8” PHM screws through each bracket to secure the end worksurface. Do not tighten completely.
5. Install one 1/4-20 x 5/8” PHM screw per bracket through the bracket and into the table leg. Do not tighten completely.
6. Install the two unit-to-unit brackets with (2) 1/4-20 x 5/8” PHM screws. Do not tighten completely.
Keep all installed fasteners
loose until step 3.
end worksurface
(curved shown)
unit-to-unit bracket with
(2) 1/4-20 x 5/8” PHMS
1/4-20 x 5/8”
PHMS
1/4-20 x 5/8”
PHMS
unit-to-unit bracket with
(2) 1/4-20 x 5/8” PHMS
2. Attach support plates to side worksurfaces
1. Place the side worksurfaces laminate-side down
onto a non-abrasive surface.
Figure 2
.
2. Attach a support plate to each worksurface with
(3) 1/4-20 x 5/8” PHM screws and tighten securely.
Figure 2
side worksurface
support plate
1/4-20 x 5/8” PHMS
(3 required)
Phillips
screwdriver
Tools
Required
Note: Steps 2-3 use parts included with the table.
