0115715 Page 3 of 3
925 First Avenue, PO Box 400, Chippewa Falls, WI 54729 Ph:
800-235-1262,
715-723-6750 Fax:
800-335-0473,
715-738-2309
E-mail: [email protected] web: www.spectrumfurniture.com
3. Install side worksurfaces
1. Set the 2 side worksurfaces onto the table and align the mounting holes.
Figure 3A
.
2. Attach each side worksurface to the table with (4) 1/4-20 x 2-3/4” PHM screws and tighten securely.
3. Install a 1/4-20 x 5/8” PHM screw through the remaining hole in each cantilever worksurface bracket and into
the side worksurface.
4. Attach each unit-to-unit bracket to the side worksurface with (2) 1/4-20 x 5/8” PHM screws.
Figure 3B
5. Line up the edges of the previously installed end worksurfaces with the side worksurfaces.
6. When everything is aligned and without gaps, tighten all worksurface and unit-to-unit bracket screws securely.
7. The center console panel can now be installed.
Figure 3A
side worksurface
(install 2nd)
1/4-20 x 2-3/4” PHMS
(4 required per side worksurface)
Phillips
screwdriver
Tools
Required
side worksurface
(install 2nd)
end worksurface
(install 1st)
end worksurface
(install 1st)
1/4-20 x 2-3/4”
PHMS
dual unit-to-
unit bracket
Figure 3B
