Cyclus 3
Sequencer
Edit page 2 – LAST STEP (Loop Points)
A Cyclus track is split up in 4 subtracks: 1 for step
note (pitch) value, 1 after your choose on edit page
XNOTE/CTRL, 1 for step length (gate time) and 1
for step velocity.
Here you can set the last step (loop point) for each
of the subtracks. If you set the last steps to different
values and lower than the Track Last Step, you will
get a new and complex track.
Edit page 3 – XNOTE/CTRL
Mode –
Choose if you want a extra note track (xnt),
or a MIDI-controller track (ctrl). The length and
note-off time for each step are the same as with the
note. If you choose Ctrl, you get the possibility to
adjust the controller values, and the time it takes to
glide from one controller value to another (for each
step).
Outp –
Xnote/ctrl track on/off. If the Xnote value
(edit page 6 & 7) is set to 0, it won’t be sent. With
Xnotes, Transponse is the same applied as on the
regular notes.
Ctrl –
Controller number.
Tweak –
Sends out controller (Ctrl) data with the
range 0..127 in Controller mode.
www.spectralaudio.ch
Page 15
Note.Xnot.Lngt.Velo.
16 09 05 14
Edit Page
Track
Pattern
Run/Stop
Note Last
Step
Xnt/Ctr
Last Step
Length
Last Step
Velo Last
Step
Mode.Outp.Ctrl.Tweak
Ctrl On 01 86
Edit Page
Track
Pattern
Run/Stop
Mode
Output
Ctrl.
No.
Tweak
