Spectracom VelaSync 1225, Руководство пользователя

Страница: 59 / 272

Static IPv4 Address : This is the unique address assigned by the network
administrator.
Table 2-8:
Default IP addresses
ETH port
Default "static lease"
IP address
ETH0 192.168.1.1
ETH1 defaults to DHCP
ETH2 defaults to DHCP
ETH3 defaults to DHCP
The default subnet is: 255.255.0.0
Netmask : This is the network subnet mask assigned by the network admin-
istrator. In the form “
xxx.xxx.xxx.xxx
.” See "Subnet Mask Values" on
page 35 for a list of subnet mask values.
IPv4 Gateway : The gateway (default router) address is needed if com-
munication to the VelaSync is made outside of the local network. By
default, the gateway is disabled.
Domain : This is the domain name to be associated with this port.
DNS Primary : This is the primary DNS address to be used for this port.
Depending on how your DHCP server is configured, this is set automatically
once DHCP is enabled. Alternatively, you may configure your DHCP server
to NOT use a DNS address. When DHCP is disabled, DNS Primary is set
manually, using the format "#.#.#.#" with no leading zeroes or spaces,
where each ‘#’ is a decimal integer from the range [0,255].
DNS Secondary : This is the secondary DNS address to be used for this
port. Depending on how your DHCP server is configured, this is set auto-
matically once DHCP is enabled, or your DHCP server may be configured
NOT to set a DNS address. When DHCP is disabled, DNS Secondary is set
manually, using the format “#.#.#.#” with no leading zeroes or spaces,
where each ‘#’ is a decimal integer from the range [0,255].
MTU : Maximum Transmission Unit. Range (for Ethernet v2): Default: 1500
bytes. Smaller packages are recommended, if encapsulation is required e.g.,
to meet encryption needs, which would cause the maximum package size
to be exceeded.
4.
To apply your changes, click Submit (the window will close), or Apply .
2.9 Configuring Network Settings
CHAPTER
2
•
VelaSync User's Manual Rev. 3 47