Spectra Logic 90841625, Инструкция по установке

Страница: 5 / 10

Gripper Jaws Replacement Guide for Spectra Logic Libraries Page 5
Disassemble the Library
Remove the Cover
1. Loosen or remove the library cover screws on the rear of the library. You will need either the #1
phillips screwdriver or the flat blade screwdriver. On libraries with phillips screws, the screws are the
captive type and cannot be removed from the cover. Loosen the screws sufficiently to fully disengage
the screws from the library frame. Flat blade screws must be completely removed from the library.
If the library is a horizontal unit, three screws hold the cover in place. If the library is a vertical unit,
four screws hold the cover in place. Figure 3 shows the location of the cover screws on a horizontal
library.
2. Slide the cover toward the rear of the library about
½
inch, Figure 4. This will release the side clips
holding the cover to the front panel.
3. Remove the cover by lifting it straight up, Figure 5.
4. Set the cover off to the side and out of the way.
Figure 3: Library cover screws on a horizontal library
Figure 4: Slide cover back Figure 5: Lift cover