Specialized Turbo Creo SL Comp E5, Руководство по обслуживанию и ремонту

Страница: 34 / 67

CREO SL: REPLACING THE SPEED SENSOR SYSTEM
REPLACING THE SPEED SENSOR CABLE: QUICK GUIDE
•
BEFORE REPLACING THE EXISTING SPEED SENSOR CABLE
•
MAKE SURE YOU RULE OUT THE SPEED SENSOR WHEEL MAGNET AS SOURCE OF ISSUE (CLEAN, ETC.)
•
MAKE SURE THE SENSOR IN CHAINSTAY IS LOCATED CORRECTLY (SEE NEXT PAGE)
• WHEN REMOVING THE MOTOR TO ACCESS THE CABLE, YOU CAN LEAVE THE LEFT CRANK ATTACHED
•
ALSO, YOU CAN REMOVE THE CHAINRING INSTEAD OF THE RIGHT CRANK AND SPIDER TO ACCESS THE MOTOR BOLTS
• REPLACING THE SPEED SENSOR SYSTEM DOES NOT REQUIRE FIRMWARE UPDATES, BUT IT IS ADVISABLE TO CHECK FOR
NEWER FW WHENEVER BIKE IS IN SERVICE
•
POWER BIKE OFF
•
REMOVE REAR WHEEL
• REMOVE THE MOTOR ACCORDING TO THE ANIMATION ON THE SERVICE WEBSITE
• INSPECT THE EXISTING SPEED SENSOR CABLE FOR DAMAGE, ESPECIALLY THE CONNECTOR
•
CHECK THE SPEED SENSOR CONNECTOR PORT AT MOTOR
•
UNSCREW THE SENSOR BRACKET IN CHAINSTAY (2MM HEX)
•
CAREFULLY PULL THE SPEED SENSOR CABLE OUT OF THE CHAINSTAY
• STRAIGHTEN THE NEW SPEED SENSOR CABLE BY HAND (CABLE IS NOT STRAIGHT DUE TO PACKAGING)
• FROM MOTOR AREA, FEED THE NEW SPEED SENSOR CABLE INTO THE CHAINSTAY SO THAT IT EXITS AT THE DROPOUT
•
POSITION THE SENSOR CORRECTLY IN THE DROPOUT (SEE NEXT PAGE)
•
SECURE THE SENSOR IN CORRECT POSITION, TIGHTEN THE PLASTIC BRACKET TO 1NM MAX. (2MM HEX)
•
RE-INSTALL THE MOTOR ACCORDING TO THE ANIMATION ON THE SERVICE WEBSITE
• RE-INSTALL THE REAR WHEEL
• CHECK SYSTEM FUNCTIONALITY