Specialized Turbo Creo SL Comp E5, Руководство по обслуживанию и ремонту

Страница: 32 / 67

CREO SL: REPLACING THE MAIN HARNESS
REPLACING THE MAIN HARNESS: QUICK GUIDE
•
REPLACING THE MAIN HARNESS REQUIRES MOTOR REMOVAL
REPLACING THE MAIN HARNESS
•
POWER BIKE OFF
•
REMOVE RE IF INSTALLED
•
REMOVE TCU AND DISCONNECT MAIN HARNESS FROM IT
• REMOVE MOTOR AND BATTERY ACCORDING TO ANIMATION ON SERVICE WEBSITE
•
REMOVE CHARGE PORT LID (4 TX 8 SCREWS)
•
TAKE OUT OLD MAIN HARNESS
•
INSTALL NEW HARNESS
•
FIRST ATTACH RE/CHARGE PORT TO FRAME BY SCREWING ON CHARGE PORT LID FROM OUTSIDE
•
ROUTE TCU CONNECTOR UP FRAME AND OUT THE TCU CUTOUT
•
CONNECT TCU (DO NOT YET RE-INSTALL)
•
REINSTALL AND CONNECT BATTERY
•
CONNECT MOTOR TO MAIN HARNESS AND SPEED SENSOR
•
POWER ON BIKE TO VERIFY SYSTEM STARTS UP NORMALLY AND SHOWS NO ERRORS
•
RE-INSTALL MOTOR ACCORDING TO ANIMATION ON SERVICE WEBSITE
•
RE-ASSEMBLE BIKE, EXCEPT TCU
• CONNECT BIKE TO TURBO STUDIO, RUN FW UPDATES IF APPLICABLE
•
RE-INSTALL TCU (SEAL USB PORT! MAX. 0.8 NM)
•
VERIFY SYSTEM FUNCTIONALITY IN STAND AND BY TEST-RIDING