12
A
B
6.7
Fig. 6.7
Both the frame and seatpost have minimum insertion requirements (A). To meet the frame
insertion requirement, the seatpost must be inserted deep enough into the frame to be visible
through the minimum insertion hole (B). To meet the seatpost insertion requirement, the
seatpost must be inserted deep enough so that the min/max line on the seatpost is no longer
visible. While both insertion requirements need to be met, for this particular frame, the frame
insertion requirement will generally be greater than the seatpost insertion requirement.
BIKE SIZE
XS
S
M
L
XL
XXL
POST LENGTH (mm)
300
300
350
350
400
400
MIN INSERTION (mm)
90
90
90
90
120
120
Insert the seatpost into the seat tube deep enough that is passes the minimum insertion
hole located on the front of the seat tube (B). The seatpost should always be visible
through the minimum insertion hole.
If the desired seat height cannot be achieved within the minimum insertion requirements
because the seatpost is too long, your Authorized Specialized retailer can trim the seatpost
to the appropriate length. If the desired seat height cannot be achieved within the minimum
insertion requirements because the seatpost is too short, the seatpost must be replaced
with a longer seatpost.
Once the saddle height is determined, torque the supplied seat wedge bolt to 6.2 Nm / 55
in-lbf.
The specified minimum insertion depths are listed in the table under Fig.
6.7. The tolerance of the ream depth can vary from frame to frame. Install a
regular 27.2 mm seatpost in the seat tube to verify the actual ream depth of
the frame.
WARNING! Failure to follow the seatpost and frame insertion requirements
may result in damage to the frame and/or seatpost, which could cause you to
lose control and fall.
If the seatpost is trimmed too short, the min/max mark on the seatpost will
no longer be accurate. Before trimming the seatpost, note the min/max
depth required by the seatpost manufacturer.
WARNING: If the seatpost needs to be trimmed, be sure to inspect it and
remove any burrs or sharp edges with a fine-grit sandpaper.
WARNING! For general instructions regarding the installation of the seatpost,
refer to the appropriate section in the Owner’s Manual. Riding with an
improperly tightened seatpost can allow the saddle and seatpost to slide
down, which can damage the frame and cause you to lose control and fall.
7. R EC O M M E N D E D T I R E P R ES SU R ES
Proper tire pressure is critical for optimal performance. Tires with higher pressure will typically roll
faster and provide less rolling resistance but provide less traction. Tires with lower pressure will
typically provide increased traction and control at the expense of rolling resistance.
Use a quality pressure gauge and refer to the tire pressure recommendations written on the
side of the tires. Please refer to the Tires and Tubes section of the Specialized Bicycle Owner’s
Manual for additional information.
Содержание SIRRUS 1.0
Страница 1: ...USER MANUAL...
