Mini-Pellet Press
7
Fill the aperture hole of the 7mm pellet die ring holder (
6
) with sufficient
KBr powder mixture to reach the top. Using a flat blade or the edge of
the spatula, level off the powder mixture such the top of the powder
mixture in the hole is flush with the 7mm pellet die ring holder’s (
6
) top
surface.
Now, take the top anvil (
8
) and place it carefully (plunger face
downwards) over the powder/7mm pellet die ring holder (
6
)/bottom
anvil (
9
) assembly. Locate the central plunger section of the top anvil
(
8
) over the powder sample within the aperture hole and use light
pressure from your hand to compact the powder mixture into the hole.
The mixture is sufficiently soft to allow the plunger part of the top anvil
(
8
) to fit and locate loosely into place in the aperture hole of the 7mm
pellet die ring holder (
6
).. (See Fig 4.)
Fig 4. 7mm Pellet Die Assembly with Sample Prior to Pressing
When this stage has been reached you can carefully transfer this
complete 7mm pellet die assembly (with sample) into the Mini-Pellet
Press for full pressing of the KBr powder sample.
Note:
The bottom anvil (
9
) has a recessed underside surface with a
metal rim around its circumference. The recess allows for central
and correct positioning of the 7mm pellet die assembly (
1
) over
the piston (
11
) of the Mini-Pellet Press prior to any pressing.
8
6
9
KBr powder mixture is
now partially compacted
within this assembly
Содержание GS03940
Страница 1: ...Mini Pellet Press User Manual 2I 03940 6...
Страница 2: ......
Страница 3: ...Mini Pellet Press User Manual 2I 03940 6...
Страница 18: ...User Manual 16 Blank Page Notes for Use of Mini Pellet Press...
