Specac Atlas 15T, Руководство пользователя

Страница: 8 / 36

User Manual
8
supporting the pump handle in an upright position. To remove these
four pieces loosen the lead screw handle (turn anticlockwise) and then
carefully lift them up and over the lead screw handle.
The press is now ready to be lifted off of the wooden pallet. There are
two holes in the upright frame supports on the sample pressing side of
the press (used for vacuum tubing when an evacuable pellet die is in
the press – see Fig 2.). These two holes can be used to lift up and
position the press by passing strong nylon rope through them to
provide a sling. If available, a hoist can be used to lift the press via this
sling. If a hoist is not available, then a minimum of two people will be
required to lift the press. Use heavy-duty gloves and lift the press from
underneath by the base casting
. DO NOT ATTEMPT TO LIFT THE
PRESS BY THE LEAD SCREW HANDLE OR PUMP HANDLE.
Fig 2. Lifting Holes and Base Casting Fixing Holes
Place the press in its working position. In certain circumstances, it may
be necessary to attach the press permanently to a laboratory bench.
Two 10 mm diameter holes are provided in the base casting for this
Holes in Frame
Supports that
can be used for
Lifting
Base Casting
Fixing Holes
(Other in
Opposite Corner)