Spearhead Swipe
E
150/
E
180/
E
210
19
19
19
19
•
AVOID wire. Stop the tractor engine immediately if an unusual noise is
heard from the machine. On no account raise or move the cutting unit until the
rotor has stopped.
Never under any circumstances run the rotor ‘to clear’ itself.
•
AVOID stumps and pipes etc. Stalling in heavy growth may cause damage
to the rotor.
•
DO NOT allow personnel near the machine while it is operating.
•
AVOID rushing into material when operating.
•
AVOID taking in too much material by selecting an appropriate forward
speed.
Stalling the Rotor
Stalling the Rotor
Stalling the Rotor
Stalling the Rotor
If the rotor does become choked the tractor will stall or the PTO clutch will slip.
If this should occur follow the instructions below:
•
Stop forward motion, disengage PTO drive immediately and place PTO
drive lever in neutral.
•
Lift the machine using tractor hydraulics.
•
Stop the tractor engine.
•
Remove any obstructions that may be present on the rotor. If working under
the raised machine ensure that it is safely supported.
•
Never under any circumstances run the rotor ‘to clear’ itself.
Cutting Height
Cutting Height
Cutting Height
Cutting Height
The height of cut can be adjusted by altering the position of the castor wheel
arm within the multi-position clevis on the main deck (Fig.11).
