Spearhead Swipe
E
150/
E
180/
E
210
18
18
18
18
TRANSPORT
Normally the machine will need to be driven to the work site. To put machine
into the transport position follow the instructions stated below:
•
Raise machine from the ground using tractor hydraulics.
•
Lock in raised position.
•
Do not transport with PTO speed drive engaged.
GENERAL OPERATION
Initial Checks
Initial Checks
Initial Checks
Initial Checks
Check that the tractor is equipped to deliver 540 rev/min at the power take-off
shaft.
UNDER NO CIRCUMSTANCES MUST THE PTO EXCEED 540 REV/MIN.
Normal Pre
Normal Pre
Normal Pre
Normal Pre----Start Checks
Start Checks
Start Checks
Start Checks
•
Check that the rotor is free from obstructions, especially pieces of wire.
•
Check that all blades are in good condition and securely attached.
•
Check that all guards are in position and that they are in good condition.
•
Examine the job to be cut. It is very important that the work site is inspected
before cutting and all hidden obstructions removed or their positions marked
so that they can be avoided.
•
Check for wire, hidden stakes, drain pipes, large stones, etc. and remove or
mark their location.
Normal Run Up
Normal Run Up
Normal Run Up
Normal Run Up
•
With a new machine never start cutting in arduous conditions, allow for at
least one day's light work for running-in.
•
Never attempt to start the machine while it is under load at any time. Always
free rotor shaft from any obstructions.
•
Never increase or decrease PTO speed rapidly as this can lead to gearbox
damage.
•
Never engage PTO at full 540 PTO speed.
•
Disengage the PTO when lifting the machine at headlands.
WARNING!
Stop the machine immediately if excessive noise is
detected from the rotor or gearbox and investigate the
cause – ensure the machine has stopped fully, the tractor
engine switched off and the key removed before
approaching the machine. Do not use the machine again
until the problem has been rectified.
Operating Hints
Operating Hints
Operating Hints
Operating Hints
•
Keep PTO speed at 540-550 rev/min to maintain rotor shaft speed.
