Spearhead Swipe
E
150/
E
180/
E
210
16
16
16
16
INITIAL RUN UP
•
Raise the machine off ground using tractor hydraulics (Fig.9).
•
Ensure nobody is standing near to the machine.
•
Run tractor engine at idle speed and engage PTO drive.
•
When rotor starts increase PTO speed gradually to 540 rev/min.
•
If rotor fails to start stop tractor engine and check PTO drive.
•
Allow the machine to run for approximately ten minutes.
Stop the machine immediately if excessive noise is heard or vibration is felt,
and refer to section on 'Maintenance'.
Pre
Pre
Pre
Pre----Work Lubrication Checks
Work Lubrication Checks
Work Lubrication Checks
Work Lubrication Checks
Gearbox: The gearbox is filled with semi-fluid grease prior to leaving the
factory, but it is advisable to check the level before putting the machine to
work, this is performed by removal of the level plug situated on the rear of the
gearbox. Warm the gearbox up before filling to the correct level with EP90
lubricant
.
Grease Points: All grease points should be greased before operating the
machine – refer to maintenance section for details.
Parking
Parking
Parking
Parking
When parking or storing the machine it should always be placed on firm level
ground for protection of the machine and safety to persons.
