Spearhead Starcut 1210, Руководство пользователя

Страница: 26 / 31

Spearhead Star-Cut
910/1210
Slip Clutch Settings
Check the condition of the friction discs before use and following periods of storage.
Release the tension from the spring, turn the clutch while holding the P.T.O
stationary. Adjust the spring compression to the original setting.
Following seasonal use, unload the spring tension and stone clutch assembly in a dry
place. Check condition of friction linings and reset spring compression to original
height before use.
Should the assembly overheat due to frequent or prolonged clutch slipping, dismantle
for inspection. The original thickness of the lining is 3.2mm, replace them when worn
to 2.5mm. Clean up all contact surfaces and replace any damaged components
before assembly.
Fig. No. Position Load Machine Setting “L” Springs
2 Centre 1400 Nm 910/1210 37.5 mm 6
2 1
st
Wing rotor 2000 Nm 910/1210 37.5 mm 8
2 2
nd
Wing rotor 1400 Nm 910/1210 37.5 mm 6
2 3
rd
Wing rotor 1200 Nm 1210
Setting “h”
3 Centre 1200 Nm 910/1210 18.9 mm
3 1
st
Wing rotor 1800 Nm 910/1210 19 mm
3 2
nd
Wing rotor 1500 Nm 910/1210 17.6 mm
3 3
rd
Wing rotor 1200 Nm 1210
Warning
The slip clutch is there to protect the gearbox. If the
blades strike a large obstacle they may get damaged or
break - avoid these conditions.
Fig 3
26