8999129: v1 11/09/2018
Page 7.1 of 7.2 pages
Original instructions (ENGLISH)
Website: www.spearheadmachinery.com
7
Removal, Storage and Disposal
Before removing the machine from the tractor, a thorough check of the machine should be made.
7.1
Preparation for Storage
At the end of the season the machine should be readied for winter storage. Carry out the following:
Clean the machine thoroughly.
7.1.1.1
Always check that the machine's safety equipment is not worn or damaged.
7.1.1.2
The PTO shaft should be cleaned, oiled and stored somewhere dry so as to avoid damage or
7.1.1.3
corrosion.
Repair any damaged components.
7.1.1.4
Replace any defective components.
7.1.1.5
Check and tighten all bolts.
7.1.1.6
Lubricate the machine following the lubrication program.
7.1.1.7
Repair any paint damage and replace any missing decals.
7.1.1.8
Smear all unpainted metal parts with protective grease.
7.1.1.9
Store the machine in a well-ventilated building.
7.1.1.10
7.1.2
Cleaning the Machine
WARNING!
Always pay attention to the area and environment when carrying out any cleaning work, this will
reduce the risk of injury to you and others.
Before cleaning:
7.1.2.1
Check the area around the machine for hazardous or loose material.
Apply the parking brake and stop the tractor.
Remove the starter key from the tractor.
Disconnect the P.T.O. shaft.
Personal Protective Equipment (PPE)
7.1.2.2
Protect your body and face when cleaning the machine. Wear the correct protective gear for body and face
when cleaning the machine. This will protect your body and face from dirt and oil splashes. Insufficient protection
of body and face can lead to severe skin and eye injuries.
Cleaning Agents
7.1.2.3
CAUTION: Some cleaning products contain chemicals that are hazardous to the environment. Always take
precautions to prevent spillage of fluids while cleaning.
CAUTION: Only use pH neutral cleaning agents when cleaning the machine. pH neutral cleaning agents give
your machine maximum protection. Cleaning agents with either high or low pH value can be corrosive
on plastic, rubber and varnished surfaces.
CAUTION: High pressure cleaning equipment may be used to clean. However, the area around the bearings
should be cleaned using gentle squirts of water.
After Cleaning: Let the remaining water run off for about one hour.
7.1.2.4
7.2
Parking
DANGER!
The machine must be correctly secured when parked in storage. A correctly secured machine
prevents serious accidents. If the machine is not properly secured when parked it can result in serious
injuries or death.