Setting the cutting height
AFTER SALES SUPPORT
01904 727505 www.spearandjackson-power.com
www.spearandjackson-power.com
AFTER SALES SUPPORT
01904 727505
14
15
OPERATION
Switching off
i. Release the switch bar.
OPERATION
i. Pull the rear and front shaft out and release them into
accordingly slots.
ii. Make sure that rear and front shaft are at same level.
GENERAL OPERATION
■
Check the product, its power cord, plug as well as accessories for
damage before each use. Do not use the product if it is damaged
or shows wear.
■
Double check that accessories or blade are properly fixed.
■
Always hold the product by its handles. Keep the handles dry to
ensure safe support.
■
Ensure that the air vents are always unobstructed and clear. Clean
them if necessary with a soft brush. Blocked air vents may lead to
overheating and damage the product.
■
Switch the product off immediately if you are disturbed while
working by other people entering the working area. Always let the
product come to complete stop.
■
Do not overwork yourself. Take regular breaks to ensure you can
concentrate on the work and have full control over the product.
NOTE:
Only operate the product at reasonable hours - not early in
the morning, late at night when people might be disturbed. Inform
yourself about local restrictions.
NOTE:
Always ensure the lever clicks back in its slot.
The original cutting height is at lowest position, before
cutting, set it to a proper cutting height.
Switching on
i. Press the button (1).
ii. Pull the switch bar (2) towards the handle and hold in
position.
1
2
