28
AFTER SALES SUPPORT
0345 605 2067
MAINTENANCE
2. Oiling port
Detach the chain bar and check the oiling port (A) for
clogging.
3. Chain bar
When the chain bar is dismounted, remove sawdust from
the bar groove and the oiling port.
Grease the nose sprocket through the grease port on the tip
of the bar.
4. To ensure that the saw’s engine retains its power,the spark
plug must be clean and have the correct electrode gap (0.6
mm).The spark plug(B) must be cleaned or replaced after
every 20 hours of service.
a. Set the 0n/0ff switch to Stop (0).
b. Remove the top air filter cover.
c. Disconnect the ignition cable from the spark plug by
pulling and twisting it simultaneously.
d. Remove the spark plug using the supplied spark plug
wrench .DO NOT USE ANY OTHER TOOLS.
e. Clean the spark plug with a copper wire brush and refit
it,or fit a new spark plug. Then replace the top cover.
5. Others
Check for fuel leakage and loose fastenings and damage to
major parts, especially handle joints and chain bar mounting
and Silencer. If any defects are found, make sure to have
them repaired before operating the unit again.
A
B