21
AFTER SALES SUPPORT
0345 605 2067
OPERATE
CHECKING THE OIL SUPPLY
NOTE!
With the chainsaw fully assembled and
adjusted it is important to check the chain oil supply
is dispensing adequate lubrication.
After starting the engine, run the chain at medium speed
and see if chain oil is being dispensed as fig. shown.
NOTE!
The oil reservoir should become nearly empty
by the time fuel is used up. Be sure to refill the oil
reservoir every time when refueling the saw.
With the chainsaw switched off, the chain oil flow can be
changed by inserting a screwdriver in the hole (A) on the
bottom of the side of the clutch. Increase or decrease
the oil flow according to your work conditions. Restart
the chainsaw and check the rate of flow meets your
requirements.
Chain oil
NOTE!
If you fail to start your machine or require further
assistance, please contact our after sales support
team at 0345 605 2067.
- When restarting immediately after stopping the
engine or when the engine is warm, it will not be
necessary to use the choke function.
Make sure the cutting blade is pointing away from
your body at all times, the chain may rotate upon
ignition.
A
