A
B
C
INSTALL ESCUTCHEON TRIM
4
A.
Measure from the finished wall to the first thread of the Adapter. Cut the Cover Tube to this length.
B.
Slide Escutcheon over the supply pipe until it is against the wall.
C.
Slide Cover Tube over the supply pipe and press into the Escutcheon.
A
B
TOWARDS
VALVE INLET
INSTALL CONTROL STOP
A.
Apply Thread Sealant Tape to the Threaded Pipe Adapter.
B.
Thread the Control Stop onto the Threaded Pipe Adapter. Using a Strap Wrench, tighten into the
final position. Outlet should point towards the Valve Inlet and be parallel to the floor.
5
A
B
REMOVE CONTROL STOP COVER
A.
Loosen, but do not remove, the Set Screw of the Control Stop Cover using the included 2.5mm
Hex Key.
B.
Remove Control Stop Cover.
6
D
C
C
A
B
FLUSH SUPPLY LINE AND INSPECT FOR LEAKS
A.
Using a Flat Tip Screwdriver, verify that the Control Stop Valve is fully closed by turning
Adjustment Screw clockwise until fully seated.
B.
Slowly turn ON water supplies and inspect for leaks and piping issues.
C.
Hold a bucket or catch basin at the outlet of the Control Stop. Slowly open the Control Stop
Adjustment Screw by turning a Flat Tip Screwdriver counter-clockwise and flush out any debris.
D.
Return the Adjustment Screw to a fully closed position.
7
B
A
VERIFY VACUUM BREAKER INSTALLATION
A.
Verify that the Split Ring and Vacuum Breaker are properly installed within the Tailpiece.
B.
Slide the Coupling Nut onto the Tailpiece as shown below.
8
Spud Nut
Fiber Washer
Rubber Gasket
Escutcheon
C
B
A
Coupling Nut
D
NOTE: Dry connections only! Do NOT use any thread sealant!
TAILPIECE INSTALLATION
A. Verify the Coupling Nut is installed as per the previous step.
B. Slide the Spud Nut, Fiber Washer, Rubber Gasket, and Escutcheon onto the Tailpiece in the
order specified.
C.
Install the Tailpiece Assembly into the fixture’s Spud.
D.
Hand tighten the Spud Nut to the fixture’s Spud. You can use a Strap Wrench, but do NOT fully
tighten.
9
