User manual
EXPERT 2K-FA
Pag. 71 of 71 Issue 2 – May 2011
To check a COM port identifier related to any given adapter, disconnect it and detect
which COM item disappears from the proposed list after that configuration change.
In case use that COM identifier to properly set the
Virtual Com Port
dialog box shown
in the picture above..
The available selection range spans thru the [
COM1…COM256
] set, and it can be
accessed using the framed slider placed above the OK and CANCEL keys.
All the other communication parameters are set as follows:
Baud-rate: 115200
Bit per character: 8
Parity check: No
and cannot be changed since they got programmed during the “SW installation”
procedure.
As mentioned above, the application usage is still the same as in ths USB interface
version described earlier, while the display window backlight changes to ivory-white as
shown in the picture below:
Using the RS 232 port becomes a necessity when the device needs to be remotized via
the Internet, since most of the committed devices currently on the market don’t
implement a USB port feature.
To be noted that in this peculiar version [
ON
] and [
OFF
] keys got intentionally disabled.
That is because switch-on and switch-off operations on the linear amplifier are directly
driven by the remotized transceiver (see Section
13.2 “REMOTE ON Connection”
on
the
User’s Manual
), while for the serial interface cable wiring consult
Section 13.5
“Port Connector”
.