SPE DFG460, Руководство по эксплуатации

Страница: 5 / 31

DFG460-5
Operating Manual
DFG460 TOOLING
The DFG460 is fitted with three drive plates that use a quick release tooling system. These
are fitted to the machine with three countersunk screws per plate. Ensure that these plates
are securely fastened to the machine prior to fitting any tools.
METAL GRINDING TOOLS
1. Disconnect the machine from the power supply.
2. Tip the DFG460 backwards onto the operator handle. The machine must be secured and
supported.
3. Fit the metal tools into the drive plates by locating the dovetail on the back of the tool into
the chamfered slot in the drive plate and slide outwards. Give the tool a tap outwards to lock
into position.
4. Repeat the above process to fit the other eight tools into the drive plates.
5. Removal of existing tools is the reverse of the above. Tap the tool inwards to unlock and
slide out of the slot in the drive plate.
6. After fitting the tools, gently lower the machine back onto the floor surface.
RESIN POLISHING TOOLS
The resin tools are fitted as a two piece system. Fitting will require a set of resin tool holders
(part no 5495 (x9)) with the Velcro backing that will accept most standard 60mm diameter
Velcro backed resin tools.
1. Disconnect the machine from the power supply.
2. Tip the DFG460 backwards onto the operator handle, the machine must be secured and
supported.
3. Fit the resin tool holders into the drive plates by locating the dovetail on the back of the
tool holder into the chamfered slot in the drive plate and slide outwards, give the tool a tap
outwards to lock into position.
4. Repeat the above process to fit the other eight tool holders into the drive plates.
5. Once all the tool holders are in place, press on the required resin tools onto the velcro
backing.
6. Changing resin tools only involves removing from the tool holder and replacing.
To remove the tool holders, tap inwards to unlock and slide out of the slot in the drive plate.
7. After fitting of the tools, gently lower the machine back onto the floor surface.
NOTE: Always use the same type and bond of tool on each of the three heads, equally worn
tools must be fitted as a set.
To ensure the correct tool is being used, check wear rates after quarter of an hour and again
at half hourly intervals, this will give an indication of total wear rates and cost per square
metres.
2