SPE DFG460, Руководство по эксплуатации, Страница: 4 / 31

DFG460-5
Operating Manual
STARTING WORK
1. BEFORE STARTING WORK ENSURE THAT THE GRINDING HEADS HAVE BEEN
FITTED, SEE PAGE 3
2. Ensure the power supply is correct for DFG460-5 - This should be a 110V 32 amp supply
from the mains or generated with a minimum of 8 kVA on 50 cycles. See Page 2 for further
details.
3. Connect a vacuum to the port at the rear of the machine to control the dust.
4. The height of the operating handle can be adjusted by using the hand-wheel at the rear of
the machine. Turning the hand-wheel anti-clockwise will raise the handle and clockwise will
lower the handle.
The grinding head of the machine can pivot and the movement can be altered by adjusting
the two grinding head stops at the front and rear of the frame.
5. Turn on the vacuum.
6. Start the machine by turning the switch on the panel to the start position. Hold for 2-3
seconds for the motor to start and then release. The switch will return to its run position.
7. To stop the machine, turn the switch to the off position.
The machine can be disassembled to enable it to fit into a small vehicle. Unplug the motor
lead from the electrical panel then take out the pins in the yokes at the base of the main
handle and also the one at the bottom of the height adjustment tube, lift the handle assembly
from the frame of the machine.
1