Spartan Equipment COLD PLANER III Series, Руководство оператора

Страница: 23 / 41

MR25664 21
OPERATION
NOTE: Avoid side to side movement while planing as this may cause excessive drum
wear or planetary failure.
WARNING! DO NOT OPERATE WITH FRONT COVER OPEN.
8. When you have reached the end of the pass, stop the skid steer and raise the planer
out of the cut. Reposition for the next cut and repeat steps 4, 5, 6 & 7. If you are not
starting a new cut, raise the planer and retract the drum into the planer housing using
the depth control cylinders. Do not transport the planer with drum turning.
WARNING! Travel only with the attachment in a safe transport position and as low as
possible for the terrain. Do not lift attachment to a height where visibility is
obstructed.
OPERATING TIPS
Milling Around Manholes
For best visibility when milling
around manholes it is recommended that
the planer be shifted to the right. The
planer is not designed to mill around tight
corners, therefore it is recommended that
four to six passes be made on each side
of the manhole. NOTE: The more passes
the less amount of manual clean-up
required.
4 TH PASS
3 RD PASS
1 ST PASS
MANUAL
CLEAN-UP
AREA
2 ND PASS
Deep Cuts
MANHOLE
OR BASIN
T
o achieve a deep cut the width of the drum, set the depth of the planer (up to 6”). This
may need to be adjusted depending on the material being milled, the desired depth, the horse-
power of the skid steer and the size of the planer. If full depth cannot be accomplished in one
pass, position the planer at the beginning of the pass and reset depth to achieve the desired
depth.
Example: Make
the first cut with the depth controls set at 2″ and then set the
depth control at 4″ for the second pass to obtain a 6” depth when it cannot be achieved
in one pass.
See Figure #1