Spartan Equipment COLD PLANER III Series, Руководство оператора

Страница: 18 / 41

16 MR25664
INSTALLATION
5. Connect the electrical wire harness from the cold planer to the auxiliary electrical con-
nector on the front of the skid steer (if so equipped). If your prime mover is not equipped
with an electrical connector and you are using the Paladin control box see the following
instructions for installing power to the control box and then connect the wiring harness
form the planer to the control box located inside of the operator
’s station.
6. Cycle the hydraulic cylinders on this product several times from fully retracted to fully
extended until all air has been completely removed from the cylinders.
7. Carefully raise the loader and cycle the tilt cylinders to check clearances and to verify
that all mounting procedures have been successfully completed.
WARNING! Do not lock the auxiliary hydraulics of your prime mover in the "ON"
position. Failure to obey this warning could result in death or serious
injury.
ELECTRIC CONTROL BOX INSTALLATION
MATERIALS NEEDED: Nylon cable ties.
1. Attach the control box to a location convenient for the operator to control the planer
without hindering operation of the prime mover. Use the magnet on the back of the con-
trol box to secure the control box with the toggle switches on top.
CAUTION! Failure to obey the following procedures may result in personal injury. To
avoid electric shock during the wiring harness installation, remove the
ground cable from the battery of your prime mover.
DANGER! BATTERY ACID CAUSES SEVERE BURNS. Batteries contain sulfuric acid.
Avoid contact with skin, eyes or clothing. Antidote: EXTERNAL - flush with
water. INTERNAL - drink large quantities of water or milk. Follow with milk
of magnesia, beaten eggs or vegetable oil. Call physician immediately.
EYES - flush with water for 15 minutes and get prompt medical attention.
WARNING! When working around batteries, remember that all of the exposed metal
parts are “live”. Never lay a metal object across the terminals because a
spark or short circuit may result.
2. Disconnect the prime mover
’s battery.
3. Remove the nut from the positive cable clamp and slide the red (positive) wire ring
terminal from the wiring harness over the cable clamp bolt. Secure the ring terminal with
the nut.
4. Remove the nut from the negative cable clamp and slide the black (negative) wire ring
terminal from the wiring harness over the cable clamp bolt.
5. Route & secure the wiring harness from the control box to the battery with nylon cable ties.