Spartan Equipment COLD PLANER III Series, Руководство оператора

Страница: 10 / 41

10 MR25664
EQUIPMENT SAFETY PRECAUTIONS
TRANSPORTING THE PLANER
• Travel only with the attachment in a safe transport position to prevent uncon-
trolled movement. Drive slowly over rough ground and on slopes.
• When transporting on a trailer: Secure attachment at recommended tie down
locations using tie down accessories that are capable of maintaining attachment
stability.
• When driving on public roads use safety lights, reflectors, Slow Moving Vehicle
signs etc., to prevent accidents. Check local government regulations that may
affect you.
• Do not drive close to ditches, excavations, etc., cave in could result.
• Do not smoke when refueling the prime mover. Allow room in the fuel tank for
expansion. Wipe up any spilled fuel. Secure cap tightly when done.
MAINTAINING THE PLANER
• Before performing maintenance, lower the attachment to the ground, turn off the
engine, remove the key and apply the brakes.
• Never perform any work on the attachment unless you are authorized and quali-
fied to do so. Always read the operator service manual
’s before any repair is
made. After completing maintenance or repair, check for correct functioning of
the attachment. If not functioning properly,
always tag “DO NOT OPERATE” until
all problems are corrected.
• Worn, damaged, or illegible safety decals must be replaced. New safety decals
can be ordered from PALADIN.
• Never make hydraulic repairs while the system is under pressure. Serious per-
sonal injury or death could result.
• Never work under a raised attachment.
• Do not use blocking made of concrete blocks, logs, buckets, barrels or any other
material that could suddenly collapse or shift positions. Do not use wood or steel
blocking that shows any signs of material decay. Do not use blocking that is
warped, twisted, or tapered.
• If the attachment must be raised, block the machine with blocks or jackstands,
NOT lift jacks or hoists. Always block the rear wheels of the planer in a manner
that stabilizes the frame.
• The mounting frame and the planer frame pivot freely. Do not place any part of
your body between these areas or under this product without stabilizing this pivot
point.