Spartan Equipment Angle Broom, Руководство владельца/оператора

Страница: 8 / 21

7.
Engaging Broom the
First Time
If this is your
initial startup with this attachment on
this machine, check the skid steer's
hydraulic oil level and add oil, if
necessary, before and after doing steps
1- 3
below.
After starting the skid steer, lift the
attachment 6" (152mm) off the ground
surface:
1. With the skid steer engine RPMs just
above idle, slowly engage the
auxiliary hydraulic to spin the broom
bristles. Move the auxiliary control
pedal, lever or switch in the opposite
directions to reverse the broom's
direction. Repeat this three times.
2. If your broom is equipped with the
hydraulically operated angle
feature, operate that function in
both directions three times also.
3. Lower the broom attachment to the
ground and shut off the skid steer's
engine and exit the operator's
compartment.
5. Check the skid steers hydraulic oil
level, and add oil if necessary.
6.
Inspect the broom's hydraulic
plumbing for any noticeable leaks.
Correct these leaks before
continuing.
Stopping the Broom
The broom quits moving when the auxiliary
control is neutralized. When
you are done sweeping for a period of time,
always rest the broom attachment on the
brackets designed to support the weight of
the broom when not in use.
To raise the rest brackets, take the weight
off the rests by lifting slightly on the broom.
Pull the lock pin out of the rest bracket
tube and raise the tube to the position
where another hole lines up for the pin.
Insert the lock pin and keeper.
Getting Familiar with the
Attachment
Never operate
the broom when bystanders are within
100' (30
m) of your work area. Flying
debris could result in Death or Serious
Injury.
Be cautious
when operating
on
un-level ground
surfaces. A machine roll over could
result in Minor or Serious Injury.
Always wear your seat belt when
operating this type of machinery.
Spartan Equipment
Angle Brooms June 2014 PAGE 7
Do not store the
broom while it is resting on the bristles as
the weight of the attachment over time will
warp or distort the shape of the bristles.