Spartan Equipment Angle Broom, Руководство владельца/оператора

Страница: 6 / 21

Skid Steer
Requirements
Your Angle Broom must only be used on
a skid steer unit with a compatible
attachment coupler.
To protect the operator from any flying
debris, it is important that the skid steer
should be equipped with a thermoplastic
polycarbonate windshield or similar
material, and similar protection on the
sides of the operator's cab.
Make sure
your skid steer is in good working
condition. Follow the operating
instructions found in the manual that
accompanied your skid steer. Failure
to do so could result in Minor or
Serious Injury.
Unpacking Your
Shipment
Your attachment arrives from the factory
banded to a wooden pallet, and requires
no final assembly before use.
Careless
removal of the shipping bands that
secure the attachment
to the pallet
could result in Minor or Serious Injury.
Clear the area of all bystanders and
stand
to the side when cutting the
bands with a pair of sheet metal shears.
Using Your Attachment
Connecting Broom to Skid
Steer
Never enter
the area underneath the coupler or
any part of the attachment when it is
in the raised position
to avoid an
accident that will result in Death or
Serious Injury.
Verify that the hydraulic hoses are clear
from the front of the attaching plate on the
attachment and that the mounting plate is
free from dirt and debris. When clear,
move the skid steer to proximity of
attachment plate. Tilt skid steer coupler
forward to align coupling point with the
upper part on the back of the attachment
plate and raise the coupler slightly.
When the top edge of the coupler is
seated in the top part of the coupler plate,
roll the skid steer tilt function back until the
attaching plate is flat against the skid
steer coupler. Lock down the coupler
levers. Note: If your skid steer is equipped
with a hydraulically operated coupler,
activate the coupler lock at this time. Shut
the Skid steer's engine off and release the
pressure in the auxiliary circuit.
Wipe off any
dirt or dust from the male or female
hydraulic flat-face couplers with a
clean rag before attaching hoses
to
keep contaminants from entering the
hydraulic system.
Spartan Equipment
Angle Brooms June 2014
PAGE 5